Заменить радиатор кондиционера спортейдж форум

На личные сообщения не отвечаю

Отправлено 11 October 2012 – 13:09

Кондиционер (общие вопросы)

Отправлено 19 October 2012 – 15:58

Отправлено 19 October 2012 – 15:59

2.
Install in the reverse order of removal, and note these items.
A.
If you’re installing a new compressor, drain all the refrigerant oil from the removed compressor, and measure its volume, Subtract the volume of drained oil from 120cc(4.20 oz.) the result is the amount of oil you should drain from the new compressor (through the suction fitting).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
D.
Immediately after using the oil, replace the cap on the container and seal it to avoid moisture absorption.
E.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
F.
Adjust the drive belt
G.
Charge the system and test its performance.

Отправлено 09 June 2021 – 16:54

Всем доброго дня, появилась следующая проблема – когда машину завожу, кондиционер работает отлично, дальше по мере прогрева холодный воздух начинает дуть более теплым( Заметил что когда стоишь в пробке, воздух идет более теплый чем при езде, хотя регулятор поставлен в максимально холодное положение. Спортаж 2,0 бензин 2015 года

Отправлено 10 June 2021 – 13:00

радиаторы езжай мыть,  грязные они.

Отправлено 10 June 2021 – 16:01

а заправлять кондей потом надо?

Отправлено 11 October 2012 – 13:05

Kia Sportage KM (2005-2010) – снятие и установка радиатора кондиционера

Replacement
1.
Recover the refrigerant with a recovery/recycling/charging station (See page HA-10).
2.
Remove the coolant reservoir, but do not disconnect the reservoir hose from the coolant reservoir and the radiator (? Engine).
3.
Remove the battery ( D Engine).
4.
Remove the bolt(A), then remove the radiator bracket(B) from the radiator.

5.
Remove the nuts (A), then disconnect the discharge line and condenser line from the condenser.
Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.

6.
Remove the bolts (A), then remove the condenser (B) by lifting it up. Be careful not to damage the radiator and condenser fins when removing the condenser.

7.
Install in the reverse order of removal, and note these items:
A.
If you’re installing a new condenser, add refrigerant oil ND-OIL8.
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Be careful not to damage the radiator and condenser fins when installing the condenser.
D.
Be sure to install the lower mount cushions of condenser securely into the holes.
E.
Charge the system, and test its performance.

Отправлено 19 October 2012 – 15:54

Kia Sportage KM (2005-2010) – снятие и установка компрессора кондиционера

Removal
1.
If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
2.
Disconnect the negative cable from the battery.
3.
Recover the refrigerant with a recovery/charging station (See page HA-10).
4.
Loosen the drive belt (See page HA-22).
5.
Remove the bolts, then disconnect the suction line (A) and discharge line (B) from the compressor. Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.

6.
Disconnect the compressor clutch connector (A), then remove the mounting bolts and the compressor (B).

Отправлено 19 October 2012 – 15:55